Scan the code to follow the Kejin official account.

Image Name

Fits and tolerances of spherical plain bearings


Fits and tolerances of spherical plain bearings
When the inner and outer rings of the spherical plain bearing are installed, there is an appropriate amount of interference in order toobtain a satisfactory radial orientation and supporting force. Improper or wrong fitwill not only reduce the service life of the bearing but also cause damage to other accessories, due to the quota and improper can cause bearing failure, such as:
Cracks, early spalling and spherical displacement appear on the spherical surface of the inner ring of the radial spherical plain bearing;
Wear between inner ring and shaft or outer ring and bearingseat of radial spherical plain bearing due to creep and abrasion;
Due to incorrect fit the internalclearance valuebecomes smaller, which may causejamming or bearing burn;
Bow | Pilling surface deformation leads to an increase in noise value and a decrease in rotation accuracy.
Fit types of spherical plainbearings andtolerancezones for shafts and holes
The matching code between the bearing and the shaft and the bearing seathole, as well as the selected shaft and hole tolerance zone shall comply with
the provisions of GB1800~1804. According to the nature of the matchingbetween the bearing inner ring(or shaft washer) and the shaft, the limit
deviation of the journal diameter, in Select from base hole fit:
a. Interference and transition fit;
b.Clearance fit;
The relative positions of the shaft and housing tolerance zones to the bearing bore and outside diameter tolerances are shown below: